Sale!

DeckWise WiseRail Heritage Cable Railing – Outside Mounts For Wood Posts

Original price was: $31.00.Current price is: $21.70.

For wood posts on a straight run, on a pitch or stairs
Budget friendly
Outside to outside mount
Tensioning device is a 2-7/8″ long threaded stud on one end and a pull-lock system on the other end.
Made from corrosion resistant, high-strength type 316 stainless steel
Sleek and beautiful design
Kit includes (1) 1/8″ diameter type 1×19 stainless steel cable with (1) pre-attached 7-1/2″ long threaded stud, (1) pull-lock fitting, with end cap (2) stainless steel washers, (2) stainless steel jam nuts
End cap to cover hex nut is optional and can be purchased separately

SKU: ZGL5A 1698633411 Categories: Home & Garden, Indoor Living Tag: DeckWise

Your needs, our top priority.
Online assistance, always at your service.
Prompt service, every time.
Protect Your Wallet with Safe Payments

The WiseRail Heritage Cable Railing -Outside Mounts for Wood Posts is a budget-friendly cable railing for any type of wood post as an outside to outside fitting on a straight level run, on a pitch or stairs. The tensioning device is a 2-7/8” long threaded stud which installs on the back side of one end post. A Pull-Lock fitting is installed through the other end.

This through-the-post configuration is the only scenario in which the economical threaded stud kits may be used. The threaded stud kits are even more economical than the WiseCable Heritage Series, but the threaded studs are a basic, functional fitting, not a hide-in-the-post solution. A brass hex nut and some metal thread will extend beyond the back of the post on one end and can be covered by an end cap (purchased separately). A Pull-Lock fitting is installed through the other end.

Use the WiseCable Heritage Series for decks with dedicated end posts for each run where the posts are situated where the back sides of the posts are all accessible. This is both the most economical solution and where the fittings are least visible.

For wood posts on a pitch or stairs, install the WiseCable Heritage Series the same as on straight runs. The tensioning device is a 2-7/8” long threaded stud which installs on the back side of one end post. A Pull-Lock fitting is installed through the other end with a post protector tube (sold separately). The WiseCable Heritage Series can be used to go up a stair and across a landing by inserting post protector tubes in the break-over post. The tube will prevent the cable from carving a groove into your post where it exits at an angle.